Disable
Accessing the DISABLE menu
To access the DISABLE menu from the MAIN
screen, enter the INSTALLER 1 or INSTALLER 2
password. Each entered digit is masked with an
asterisk symbol.
The INSTALLER 1 and INSTALLER 2 users can access
all the options described in the user manual. Refer
to the FC503 and FC506 Addressable Fire Control
Panels User Manual for more information.
Both INSTALLER 1 and INSTALLER 2 users can access
option 9 Sounders. Only the INSTALLER 1 user can
access option 7 Password.
7 Key - password (DISABLE)
The password (DISABLE) option is only enabled if
you enter the master INSTALLER PIN in the control
panel. The default PIN is 00000.
The 7 Key is used to select the DISABLE password
option. Select the option to DISABLE or ENABLE the
corresponding password. See Figure 41.
Select the password
In this phase, the keypads and the keys have the
following functions:
Alphanumeric keypad
Use the alphanumeric keypad to select the
identification number of the password.
Cursor keys
Table 56: Cursor key functions in select the
password
Key Function
Up Show the next type of password
Down Show the previous type of password
Right No function
Left No function
Note: The types of passwords are User
password or INSTALLER password.
ESC and ENTER keys
Table 57: ESC and ENTER key function in select
the password
Key Function
ESC Cancel the operation or return to the
previous screen
ENTER Confirm the selection
Disable the password
In this phase, the display shows the current status
of the selected User or Installer password. The
possible actions are: ENABLE or DISABLE.
Alphanumeric keypad
No function is related to the alphanumeric keypad.
Cursor keys
No functions are related to the Up, Down, Right, or
Left keys.
ESC and ENTER keys
Table 58: ESC and ENTER key function in disable
the password
Key Function
ESC Cancel the operation or return to the
previous screen
ENTER Confirm the selection and move to the
MAIN screen followed by a panel reset
9 Key- sounders
The sounders option is visible only if you enter
the Control Panel using the INSTALLER 1 (default
00000) or INSTALLER 2 (default 99999) password.
Each entered digit is masked with an asterisk. Use
the sounders option to enable or disable all the
sounders on the board or on the loop: SC1, SC2,
loop sounder outputs (SAM, SAB, SNM, AV bases
Symphoni sounders).
Press 1 to enable all sounders: the event ALL
SOUNDERS ENABLED is memorized into the log.
Press 2 to disable all sounders: the event ALL
SOUNDERS DISABLED is memorized into the log.
FC503 and FC506 Addressable Fire Control Panels64
Johnson Controls - CONFIDENTIAL
To Next Page
Loading...
