Note: Long press (press for more than 1 s) the
0 key to clear the entered data and return the
cursor to its starting point.
Cursor keys
Table 7: Cursor keys functions
Key Function
Up Use for upper-case letters
Down Use for lower-case letters
Right Use to scroll along the line
Left Use to scroll along the line
ESC and ENTER keys
Table 8: ESC and ENTER key functions
Key Function
ESC Use to cancel the operation and
return to the previous screen
ENTER Use to confirm the entered
text and proceed or use in the
MAIN screen to signal a local
programming activity followed by
a panel reset
Assistant text composition
To simplify the entry of text strings, an assisted
procedure has been included, based on a pre-
compiled list of 128 vocabulary words with a
maximum of 18 characters. When one of the
numeric keys is pressed to enter a letter, the first
word in the list that begins with that letter will be
inserted. The Up and Down arrows will load the
next or the previous word in the list.
Activate the assisted entry procedure by pressing
the Up key for more than 3 seconds. Deactivate the
assisted entry procedure by pressing the Down key
for more than 3 seconds. See Figure 19.
Figure 19: Assisted entry procedure
Callout Description
1 Device coordinate
2 Assisted procedure active
3 Cursor
4 Entry area
5 Vocabulary area
When the assisted entry procedure is active, the
string Vocabulary ON blinks on the upper right
area of the LCD display. In the Vocabulary area the
word currently selected in the row aligned with the
Entry area displays. The word that precedes it in the
vocabulary displays in the upper row while the next
word displays in the lower row. In the Entry area the
words used to compose the label display.
To enter a word, press the numeric key (more than
one time if necessary) related to the first letter of
the word that needs to be entered. If this word is
not correct, scroll through the vocabulary using
the Up and Down keys until a suitable word is
found. During the vocabulary scan, the word in the
middle row is entered in the Entry area at the cursor
position. Use the Left and Right keys to move the
cursor to the beginning of each word.
Single selection
Use single selection to select a single value between
a set of possible values. The maximum number of
values is 8.
ON off
^
The selected value displays in upper case. The
selection of a new value will automatically deselect
the previously selected value.
In this phase the keypad and keys have the
following functions:
Alphanumeric keypad
No function is related to the alphanumeric keypad.
FC503 and FC506 Addressable Fire Control Panels 37
Johnson Controls - CONFIDENTIAL
To Next Page
Loading...
