46
Glass Pane Removal
1. Remove the screws securing the top retaining
bracket. (no. 1)
2. Loosen the screws on the insulation retainer
panel. (no. 3)
3. Slide out the heat reflective glass pane. (no. 4)
4. Remove the inner glass pane and gasket.
Note: If transferring the gasket to a replacement
glass pane then ensure the gasket join is located at
the top of the door.
Note: The glass pane has a reflective coating on
one side only. Ensure that the coating is facing
AWAY from the oven cavity when reassembled.
• To test if a glass pane has a heat reflecting
coating, use an ohmmeter to test for continuity
on the glass surface. If there is continuity then
the glass will be coated and it will read between
13-16 ohm.
• The part number on the bottom L/H corner
should be facing the customer.
Reassembly
• Refit in reverse manner.
• Ensure all glass surfaces are clean.
Handle Removal
1. Clear the insulation from around and remove
the handle retaining screws in the top corners
of the outer door assembly.
Reassembly
• Refit in reverse manner.
Glass Pane Removal
1. Remove the screws securing the heat shield
panel.
2. Loosen the four screws securing the bottom
flow guide panel.
3. Slide the heat reflective glass pane out from
the bottom flow guide panel.
Reassembly
• Refit in reverse manner.
To Next Page
Loading...
