51
Temperature Module Removal
1. Remove the wiring harnesses from the
temperature module.
2. Remove the knob by pulling it off the
encoder shaft, and then remove the bezel by
turning it anti clockwise to release. We
recommend the use of a pair of
long nose pliers
3. With the bezel removed the encoder will now
release from the temperature module.
4. To release the temperature module from
the control panel, depress the clips on the
top corners of the housing and pull
the function switch forward to release from
the bracket.
Clips
8.7 Removal of the Power Module
There are 2 power modules in a double model. The master board is the upper cavity module, and
the slave board is the lower cavity module. Both these modules are connected via a harness and are
located in the top panel area.
A single model only has one power module which is the master board.
1. Remove the oven doors. This makes the
product lighter and easier to move, and will
stop it tipping forward when pulled out from
the joinery.
2. Remove the screws securing the product to
the joinery and slide the oven forward out of
the joinery approx 250mm.
3. Remove the 2 front service panel screws on
either side and the front 2 rear panel screws.
4. Lift the service panel and slightly tilt to remove
it from the control panel. Slightly raise the rear
panel to gain access to the power module.
5. To remove the power module, use a pair of
long nose pliers and squeeze the plastic
standoff to release.
6. When replacing the power module ensure you
take note of the wiring harness positions.
7. Reassemble in reverse order, and once
powered on, ensure the model ID is set for the
model you are working on, refer to page 33 for
the model ID references.
Procedure:
squeeze
to release
To Next Page
Loading...
