Fisher & Paykel OB76DD - Removal of the Cooling Fan; Removal of the Vent Fan

57
8.17 Removal of the Cooling Fan
1.
Ensure the product is isolated from the power
supply.
2. Remove the product from the joinery, refer to
section 8.1.
3. Remove the rear panel to gain access to the
cooling fan(s).
Single models and double upper cavity
4. Remove the wires from the cooling fan motor.
5. Remove the two screws on the cooling fan and
slide it out from the locating slot.
6. Remove the four small retaining screws for the
cooling fan side brackets and transfer the
brackets to the replacement cooling fan.
7. Reassemble in reverse order.
Double model lower cavity
8. Follow instructions 1 to 3.
9. Remove the wiring to the lower cooling fan.
10. Remove the two screws on the right of the
cooling fan and slide it out from the locating
slot.
11. Remove the four small retaining screws for the
cooling fan side brackets, and transfer
the brackets to the replacement cooling fan.
12. Reassemble in reverse order.
screws
screws
1.
Ensure the product is isolated from the power
supply.
2. Remove the product from the joinery, refer to
section 8.1.
3. Remove the rear panel to gain access to the
vent fan(s).
Removal
Single model and double upper cavity
2. Remove the vent fan retaining screws.
3. Remove the longest section of vent ducting.
4. Remove the vent fan wires.
5. Lift the vent fan out of the vent ducting and
rotate counter-clockwise to clear surrounding
parts.
6. Separate the vent fan from the vent tube.
For lower cavity in double ovens
2. Remove the vent fan retaining screw.
3. Remove the lower section of vent ducting.
4. Remove the vent fan wires and transfer them
to the replacement fan.
5. Separate the vent fan from the vent tube.
Reassembly
Refit in reverse manner.
8.18 Removal of the Vent Fan