Fisher & Paykel OB76DD - Removal of the Door Lock Assembly

59
8.21 Removal of the Oven Door Lock Assembly
The door lock is situated on the left hand side of
the product. If the door lock is engaged and the
door cannot be opened, refer to the following
procedure.
1. Remove the oven from the joinery (refer to
Section 8.1)
2. Remove the front door lock inspection
panel on the side.
3. Remove the link pin circlip and disconnect
the link arm.
Note: Take care not to lose the link pin circlip
or pin.
The door lock will now be free to disengage.
If the door lock needs to be replaced refer to
following procedure:
Removal of lock assembly
1. Remove the door switch wiring harnesses
from the power module.
2. Remove the wiring harness to the lock
motor.
3. Remove the front and rear door lock
assembly retaining screws.
4. Remove the wire connector from the door
switch. (This is only necessary for
the upper door lock on a double oven.)
5. Slide the door lock assembly out the rear of
the side panel.
Note: Take care not to lose the door switch
spring when removing the door lock assembly.
Reassembly
Refit in reverse manner.
circlip
Door lock
harness
screw
link arm