Fisher & Paykel OB76DD - Dissassembly of the Control Panel

50
8.6 Disassembly of the Control Panel
The control panel is made up of a clock module, function module and a temperature module.
There are differences between double and single models, so ensure you order the correct parts from
the correct parts book for the model you are servicing.
1. Remove the wiring harnesses from the clock
module.
2. Depress the locking clip and slide the
securing bracket to release.
3. The bracket will be able to be removed.
4. Lift the module up to release from the
control panel.
Slide
lock clip
Function Board Removal
1. Remove the wiring harnesses from the
function module.
2. Remove the knob by pulling it off the
encoder shaft, and then remove the bezel
by turning it anti clockwise to release. We
recommend the use of a pair of long
nose pliers.
3. With the bezel removed the encoder will now
release from the function module.
4. To release the function module, depress the
clips on the top corners of the housing and
pull the function switch forward to release
from the bracket.
Clock Module Removal