To Next PageTo Next PageHow to clean a clogged vent on a Fisher FIELDVUE DVC6200?
To address a clogged vent in your Fisher Controller, you can remove, clean, and then replace the vent. Start by lightly brushing the vent's exterior to eliminate any contaminants. Next, flush a gentle water and detergent mix through the vent to ensure it's completely clear. Make sure the vent is fully dry before you reinstall it.
General| Type | Digital Valve Controller |
|---|---|
| Operating Temperature Range | -40 to 85 °C (-40 to 185 °F) |
| Enclosure Rating | NEMA 4X, IP66 |
| Input Signal | 4-20 mA, HART |
| Communication Protocol | HART |
| Supply Pressure | 1.4 to 7 bar (20 to 100 psi) |
| Diagnostics | Valve signature |
| Approvals | ATEX, IECEx, FM, CSA |
| Power Supply | Loop powered |
Defines the manual's coverage, including specifications, installation, maintenance, and parts for the DVC6200.
Explains navigation paths and fast-key sequences for Field Communicator use.
Explains how to mount the DVC6200 controller on various actuator types.
Details how to mount the DVC6205 base unit onto a pipestand or wall.
Provides steps for mounting the DVC6215 feedback unit on different actuators.
Details the wiring process for connecting the DVC6200 to a 4-20 mA control loop.
Explains how to connect the DVC6205 base unit to the DVC6215 feedback unit.
Sets the operational state of the instrument for setup or service.
Automates instrument setup using specified actuator information.
Covers advanced configuration parameters for the DVC6200.
Configures instrument operating modes and protection levels against unauthorized changes.
Adjusts valve response parameters including tuning, input characterization, and dynamic response.
Details automatic and manual procedures for calibrating valve travel.
Covers calibration of pressure and analog input sensors.
Describes how to adjust the pneumatic relay for double-acting actuators.
Describes how to view and interpret instrument alerts and their causes.
Details how to perform and configure partial stroke tests for valve diagnostics.
Provides steps for removing and replacing the magnetic feedback assembly.
Offers solutions for common instrument communication and performance issues.
Provides guidance on how to order replacement parts and kits.
Lists available spare parts kits for servicing the DVC6200.
Describes the HART protocol for digital communication with field devices.
Explains the internal components and operation of the DVC6200.
Shows the menu navigation paths for HC, AD, PD, and ODV instrument levels.
Details the menu structure for instrument level AC.
Defines how the instrument receives its set point (Analog or Digital).
Sets the instrument's operational state for setup or service.
Determines if commands can calibrate or configure parameters.
