Q9. What to do with the Wi-Fi connection failure?
1. Please check if the Wi-Fi name contains special characters. If so, modify it and try again.
2. Please check if the password contains special characters. If so, modify it and try again.
Q7. What to do if your print is warping or not adhering well?
Solution 1: Increase the bed temperature to improve adhesion between the bed and your print.
Solution 2: Add a brim when slicing your model.
Solution 3: Apply glue.
Solution 4: Clean the bed to remove any grease or residue.
Solution 5: Check if the bed is level. The leveling and calibration function can be used.
Q8. What to do if print files can not be found and the screen
displays only folders after inserting the USB flash drive?
The USB flash drive format may be incorrect. The device supports the FAT32 file
system. Please format the USB flash drive to FAT32.
Q6. Can filaments from other brands be used?
Yes. You can use filaments from other brands, but certain parameter adjustments are required
due to slight temperature differences in different filaments.
24
To Next Page
Loading...
