Flashforge Finder 2.0 - Page 17

Finder2.0 User Guide |
www.flashforge.com
0086-0579-82273989
17
Tap [Setting] to enter the setting interface
 Language: To set the display language
 WiFi: To turn on/off the WiFi.
Wlan hotspot: To turn on/off the Wlan
hotspot.
 Polar Cloud Connection:
To turn on/off the Polar Cloud Connection.
 FlashForge Cloud Connection:
To turn on/off the FlashForge Cloud
Connection.
Extruder Calibration: To adjust the initial
distance between the extruder and the build
plate.
Startup Sound: To turn on/off the Startup
Sound.
 Light Bar Control: To turn on/off the light
bar control.
Factory Reset
：
Return to factory setting.
Update: To update the firmware version.
Back
WiFi:
Turn on WiFi: Turn on the WiFi, release
the WiFi hotspot and set the WiFi on
computer.
Back