Finder2.0 User Guide |
www.flashforge.com
Method 1：Connect Via USB Cable
a. Connect your Finder2.0 with your PC via an USB cable.
b. Turn on your Finder2.0 and start Flashprint.
c.Click [Print]--[Connect Machine], then select USB in the [Connection Mode]
option and select machine you want to connect in [Select Machine] option. If you can
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, it means you haven’t installed the driver in the software.
Method 2： Connect Via WIFI
①Connect Finder2.0 with your PC under AP mode
b.Tap [Tools]-[Setting]-[WIFI]-[WIFI ON]
c. Click on the wireless network on the left bottom, and find the wireless signal-
“Finder2.0”. Click [Connect] to finish network connection.
d. Click[Print]-[Connect Machine] on Flashprint. Then the following dialog box
pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
To Next Page
Loading...
