Flashforge Finder 2.0 - Page 79

Finder2.0 User Guide |
www.flashforge.com
0086-0579-82273989
69
8-6
Advanced
1） Stepper Motor Voltage(Usually keep default)
a. X-Axis: Voltage parameter of X-axis stepper motor. The bigger the value is,the
more heater will produce.
b. Y-Axis: Voltage parameter of Y-axis stepper motor. The bigger the value is, the
more heater will produce.
c. Z-Axis: Voltage parameter of Z-axis stepper motor. The bigger the value is,the
more heater will produce.
d. A-Axis: Voltage parameter of right-extruder stepper motor. The bigger the value is,
the more heater will produce.
e. B-Axis: Voltage parameter of left-extruder stepper motor. The bigger the value is,
the more heater will produce.
2） Others
a.Extrusion Ratio: The filament amount extruded by the extruder. Default: 109%
Max:125% (Usually the default ratio is suggested)