Flashforge Finder 2.0 - Page 80

Finder2.0 User Guide |
www.flashforge.com
0086-0579-82273989
70
b. Path Width: The width of the path, the default value is 0.4mm. Keeping default is
suggested.
c. Path Resolution: The default value is 0.1mm. The bigger the value is, the lower the
extrusion resolution is. On the contrary, the extrusion resolution is much higher.
8-7
Others
Dimensional Adjustment
a. Enable Adjustments: Enable software to make compensation forerrors.
b. External Compensation: Enable software to make compensation for the outer
diameter error.
c. Internal Compensation: Enable software to make compensation for the inner
diameter error.
8-8