NOTICE
SAFETY NOTICE: PLEASE CAREFULLY READ AND STRICTLY FOLLOW
ALL THE SAFETY WARNINGS AND NOTICES BELOW ALL THE TIME.
WORK ENVIRONMENT SAFETY
Please keep the work table of the equipment clean and tidy.
Please ensure that the equipment is away from combustible gases, liquids and
dust when it is in operation. The high temperature generated by equipment operation
may react with combustible gases, liquids, and airborne dust, thus causing fire.
Children and untrained personnel are not allowed to operate the equipment alone.
ELECTRICAL SAFETY
Be sure to ground the equipment. Do not modify the plug of the equipment.
Ungrounded equipment/improperly grounded equipment/modified plug will
inevitably increase the risk of electric leakage.
Do not expose the equipment to damp or hot-sun environment. Humidity will
increase the risk of electric leakage. Exposure to sunlight will accelerate the aging
of plastic parts.
Make sure to only use the power cord provided by Flashforge.
Do not use the equipment during an thunderstorm.
Please shut down the equipment and unplug it if it is not in use for a long time.
PERSONAL SAFETY
Do not touch the extruder, build plate, etc., during printing.
Do not touch the extruder and build plate when finishing printing in order to avoid
high temperature burns or mechanical damage.
Do not wear scarves, masks, gloves, jewelry ornaments or other objects that can
easily get tangled into the equipment when operating it.
Do not operate the equipment while you are tired or under the influence of drugs,
alcohol or medication.
CAUTIONS
Keep the inside of the equipment clean and tidy. Do not drop metal objects into the
sliding chute at the bottom of the build plate.
Please clean up the filament debris in time. It is recommended to operate this outside
the equipment.
Any modification of the equipment by yourself will result in the situation that you will
not be entitled to warranty rights anymore.
Please keep the distance between the extruder and build plate for at least 50mm
during filament loading. Too-close distance may cause nozzle clogging.
02
To Next Page
Loading...
