The room temperature should be between 15℃ and 30℃.
The humidity should be between 20RH% and 70RH%.
Please operate the equipment in a well-ventilated environment.
Do not use the equipment for illegal activities.
Do not use the equipment to make any food storage products.
Do not put the printed model into your mouth.
EQUIPMENT ENVIRONMENT REQUIREMENTS
EQUIPMENT PLACEMENT REQUIREMENTS
COMPATIBLE FILAMENT REQUIREMENTS
FILAMENT STORAGE REQUIREMENTS
LEGAL STATEMENT
The equipment must be placed in a dry and ventilated environment. A distance of
at least 60cm must be reserved around the front, back, left and right sides of the
equipment. The storage temperature should be between 0℃ and 40℃.
When using the equipment, it is recommended to use Flashforge’s filaments.
If non-Flashforge filaments are used, there will be certain differences in material
characteristics, and thus printing parameters may need to be adjusted.
Please store filaments in a dry and dust-free environment after unpacking. It is
recommended to use the matching filament dry box for storage.
The user has no right to make any modification to this user guide.
Flashforge will not be responsible for any safety accidents caused by the disassembly
or modification of the equipment by the customer. No one is allowed to modify or
translate this guide without the permission of Flashforge. This guide is protected by
copyright, and Flashforge reserves the right of the final interpretation of this guide.
First Edition (May 2022)
Copyright © 2022 Zhejiang Flashforge 3D Technology Co., Ltd. All Rights Reserved.
03
To Next Page
Loading...
