GuiderⅡ User Guide | www.flashforge.com
To set extruder temperature during printing:
After extruder temperature has reached
target temperature, temperature figure will
be underlined in print interface,
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
Tools in print interface
Printing speed: To change printing speed
during printing by tapping the underlined
speed figure.
Light bulb: To turn on/off the light.
Filament: To change filament during
printing. (Note: You need to suspend the
printing operation first)
Cancel: To end the tool orders and return
to the print interface.
To set the printing speed during printing
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
To Next Page
Loading...
