GuiderⅡ User Guide | www.flashforge.com
Tap the [Preheat] button to enter the
preheat interface. Tap the [Star t] button to
heat up to the setting temperature.
The default temperature is 220℃.
Tap the temperature display bar to set the
temperature.
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
The picture displays the preheat interface. It
shows the actual temperature and the target
temperature. Tap the [Abort] button to
abort the preheat job.
Tools
Tap [Tools] to enter tool options.
Filament: To load/unload the filament.
Level: To adjust the build plate.
Home: To make the X, Y and Z axes
back to the zero point.
Manual: To manually adjust the positions
of X, Y and Z axes.
Setting: To implement relevant function
setups.
Status: The check the real-time status of
the printer.
About: Information about the printer.
Back
To Next Page
Loading...
