Flashforge Guider II - 7.2.2 Print from Computer (WiFi connection)

GuiderⅡ User Guide | www.flashforge.com
59
②Turn on your Guider Ⅱ, level the build plate and load the filament.
③Click [Pr int] and transfer your Gcode file to your Guider Ⅱ. After completing
transference, the printer will heat up automatically. And when heating finishes, the
print will start to build the model.
④ When your PC connects with FlashPrint successfully. The status box on the
bottom right displays the real-time nozzle temperature. After finishing preheating,
your Guider Ⅱ starts the print job directly.
7.2.2 Pr int fr om Computer (WiFi connection)
① Connect your Guider Ⅱ with your PC via WiFi. (Please refer to 6.2.13 )
Enter into the IP Address shown on your GuiderII interface and then click
[Connect].