GuiderⅡ User Guide | www.flashforge.com
② Turn on your Guider Ⅱ, level the build plate and load the filament.
③ Click [Print] and transfer your Gcode file to your Guider Ⅱ. After
completing transference, the printer will heat up automatically. And when heating
finishes, the printer will start to build the model.
If you want to print a Gcode from a local folder, you just need to load the file into
FlashPrint at the status of USB connection or WiFi connection, then click the [Print]
● Load the target Gcode file into FlashPrint.
● Click the [Pr int] button, the PC will transfer the Gcode file to the printer.
To Next Page
Loading...
