Flashforge Guider II - 7.2.3 Print from USB Stick; 7.2.4 Print from Computer (Ethernet Cable connection); 7.2.5 Print from Polar Cloud connection

GuiderⅡ User Guide | www.flashforge.com
61
● After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.
7.2.3 Pr int fr om USB Stick
①Insert your USB stick with target .g or .gx file to your Guider Ⅱ. .
②Turn on the GuiderⅡ. Make sure the build plate has been leveled and the filament
is loaded.
③ Tap [Pr int] and then tap the USB Stick icon in the middle. The file(s) will be
displayed on the screen. Select the file you want to print and tap [Pr int]. The file will
be transferred to the printer.
⑥ And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abor t：To stop heating and printing. Once you tap [Abor t], the process is irreversible.
Pause：To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
7-11