GuiderⅡ User Guide | www.flashforge.com
7.2.4 Pr int fr om Computer (Ethernet Cable connection)
①Connect your GuiderⅡ with your PC via a Ethernet cable.
Enter into the IP Address shown on your GuiderII interface and then click [Connect].
②Turn on your Guider Ⅱ, level the build plate and load the filament.
③Click [Pr int] and transfer your Gcode file to your Guider Ⅱ. After completing
transference, the printer will heat up automatically. And when heating finishes, the
print will start to build the model.(Same procedure, Please refer to 7.2.2 )
7.2.5 Pr int fr om Polar Cloud connection
1）Register a Polar Cloud account with your computer, on website:
https://polar3d.com/
Register your account using one of the four following options, take the third microsoft
live option as an example, create your new Polar Cloud account.
To Next Page
Loading...
