Flashforge Hunter - Chapter 3. Unpacking

Hunter User Guide | www.FlashForge.com 400-699-1063
15
Chapter 3. Unpacking
This chapter will present you the whole unpacking procedure of Hunter 3D
printer.(Note: Make sure you read the whole unpacking guide)
1. （3-1）Put Hunter package on the clean, tidy workbench, using a knife to cut the
tape from the bottom.
3-1
2. （3-2）Set the Hunter upright, lay the white foam on the floor and lift the carton.
3-2
3.
（
3-3
）
Remove the foam and accessory box from top. You will find a Quick Start
Guide, an After-Sales Service Card and a Spare Vat Film inside.