Hunter User Guide | www.FlashForge.com 400-699-1063
Chapter 4 . Hardware Assembly
The Hunter comes pre-assembled and is almost ready-to-print (ARP). All you need to
do is to plug into the electronic power and pour the photopolymer resin. It will only
take between 5 to 10 minutes before you can start up the Hunter and prepare for your
first 3D print!
4.1 Pour Photopolymer Resin in to Vat
(4-1) There is a 100ml bottle of photopolymer resin in each Hunter. Tear off the seal
open the cap, there is a rubber plug at the mouth of the bottle. Lift the ring open and
take out the rubber plug. Please put on gloves during operation.
(4-2) Pour the photopolymer resin into resin vat slowly, fill it one-third full each time.
Don’t go over than the maximum scale mark. Be sure not to pour too fast to avoid
spilling. Before pour the resin please make sure the vat dustless without fingerprints.
Clean the vat with non-woven cloth if it is necessary.
To Next Page
Loading...
