Hunter User Guide | www.FlashForge.com 400-699-1063
Click the Support Options, an option box will appear, supports options only include
Overhang Thresh: The parameters used to judge whether the model surface need to
generate the supports. The higher the value is , the less the supports are. The value is
Tip Diameter: The diameter size of support and model contact parts, the bigger
diameter the stronger support, and harder to remove. The value is between 0.25mm to
Post Diameter: The diameter of support post, the larger the diameter of supporting the
stronger it will be, the more difficult to spin off. The value is between 0.25mm to
Base Diameter: The diameter of the bottom post, the larger the base diameter the
easier supports stick to the built plate, the more difficult to spin off. The value is
Base Height: The height of the support at the bottom of the bold part, the higher the
base height, the stronger support bottom, the more difficult to spin off. The value is
Post Space: The spacing among posts, the smaller the value the closer the posts. The
value is between 1mm to 10mm.
To Next Page
Loading...
