1. Wear high-temperature gloves.
2. Preheat the build plate with a magnetic agitator.
3. Wipe with dustless paper after surface residue material is
soften.
4. When cleaning the printing platform, make sure that both
sides and surroundings of the build plate are cleaned.
10. Clean the solvent on the surface of the model via dissolved
solvent II for 2-10min.
11. Remove the model from the mesh basket in dissolved
solvent III for 20 seconds.
papers or things alike.
7.2 Clean up build plate
Note: The build plate should remain clean before
installing and using the build plate. Keep room
temperature steady.
Note：The wax objects can be picked up with a thin
wire, or it can be picked up with a tweezers wrapped
with a hose at the front.
After each removal of the model, it's necessary to clean up
the build plate and plug it back into the printer. Follow these
steps to clean up the build plate.
Before proceeding, prepare the following items:
· Magnetic stirrer · Dust-free paper
· High temperature-resistant gloves.
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32 33 34
35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
