Chapter 8 Maintenance
There are some necessary maintenances for WaxJet® 400/410 series regularly.
Maintain the schedule
Note: Maintenance tasks must be performed regularly to ensure good operation of the equipment and the accuracy of printed
objects.
Clean the waste box
Daub oil for X-axis guide
Daub oil for Y-axis guide and the motor
screw rod
Daub oil for Z-axis guide and the motor
screw rod
Clean the X-axis base
Clean internal dust
Clean dust around the sensors
Clean the outer surface
Clean build chamber
Clean build plate
Clean the touchscreen
Clean the carriage of printhead
Clean the bottom side of Y-beam
Powder Removal for Pipes
Clean the planarizer and its blade
As needed
Every day
Every week
Every month
Every half year
The recommended operating environment recommends operating temperature range: 18-28 degrees C (64-82 degrees F)
Note: For routine maintenance, the printer must be on standby and a clean build plate must be installed.
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32 33 34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
