Preface
Note:
Dear Flashforge users，
Thanks for your choice of Flashforge products and thanks
for your supports for Flashforge.
The Flashforge 3D printers are of high quality and
excellent performance. Even if you are familiar with earlier
FlashForge machines or 3D printing technology, we still
recommend that please read this guide, as there is lots of
important information about the WaxJet 400/410 series for
you to get a better 3D experience. The entire Flashforge team
is always ready to provide you with the best quality service.
If the issues that are not covered by this guide while using the
printer, please contact FlashForge's customer support.
Please visit the FlashForge website for contact information:
printer before contacting after-service team.(see "Firmware
version" on page 23) and hardware serial number (see
"Identify Printer" on page 16).
Each device must be tested before leaving factory. If
there are some residues in nozzles or some tiny
scratches on the build plate, it is normal and won’t
affect the printing quality.
Introduction
The WaxJetPrint software is constantly being updated and
screenshots in the user guide are for reference only. The
FlashForge WaxJet® 400/410 3D Printer User Guide contains the
information needed for you to set up and use this device.
This User Guide including the following parts: Preface,
Introduction and After-sale service.
The Preface section includes resource acquisition channel,
the overall framework of the manual, and the problems that
should be paid attention to while printing.
The introduction section contains the overview of 3D
printing technology, equipment introduction, unpacking and
installation of equipment, software installation and use.
After-sale section contains the user how to get the support
and help.
Note
· Please read 《Flashforge WaxJet® 400/410
Industrial 3D printer User Guide》before opera-
tion.
· The WaxJetPrint software is constantly being
updated and screenshots in the user guide are for
reference only.
The service
If there are some software issues that are not covered by this
guide, contact FlashForge's Customer Support.
Please visit the FlashForge website for contact information:
printer before contacting after-service team.(see "Firmware
version" on page 23) and hardware serial number (see
"Identify Printer" on page 16).
Software support
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30 31 32 33 34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
