ISO ANSI Warning
--- Warning - corrosive substances
--- Warning - suspended load
--- Warning - hand injuries
ATEX certification
Explanation regarding Machinery Directive 2006/42/EC
The couplings described here are “components” in accordance with the Machinery Directive
and do not require a declaration of incorporation.
ATEX Directive
The term "ATEX Directive" used in these instructions stands for the harmonisation legislation
of the European Union in compliance with the declaration of conformance for equipment and
protective systems for correct use in hazardous zones.
Protective clothing
In addition to the generally prescribed personal protective equipment (safety shoes, overalls,
helmet, etc.), also wear suitable safety gloves and safety goggles when handling the coupling.
Using the coupling
The relevant work safety and environmental protection regulations must be complied with at
all times during transport, assembly, installation, dismantling, operation and maintenance of
the coupling.
Only qualified personnel may operate, assemble, maintain and repair the coupling. Information
about qualified personnel can be found in the legal notes at the beginning of these instructions.
If lifting gear or load suspension devices are used for transporting, these have to be suitable
for the weight of the coupling.
If the coupling has visible damage, it may not be assembled or put into operation.
The coupling may only be operated in a suitable housing or with touch protection according to
applicable standards. This also applies to test runs and rotational direction checks.
Work on the coupling
Only carry out work on the coupling when it is not in operation and is not under load.
Safety instructions
2.1 General information
N-EUPEX / N-EUPEX DS 3100en
12 Operating Instructions 10/2017
To Next Page
Loading...
