Spare parts
11
11.1 Ordering spare parts
By stocking the most important spare parts at the installation site you can ensure that the
coupling is ready for use at any time.
Note
Original spare parts
Only use original spare parts from Flender. Flender only accepts liability for original spare parts
from Flender.
Other spare parts are not tested and approved by Flender. Non-approved spare parts may
possibly change the design characteristics of the coupling and thus impact active and/or
passive safety.
Flender will accept no liability or warranty whatsoever for damage occurring as a result of the
use of non-approved spare parts. The same applies to any accessories that were not supplied
by Flender.
You can find the available spare parts for the coupling described here at Spare parts drawing
and spare parts list (Page 54).
You will find our contact data for ordering spare parts in Service and support (Page 49).
Information required when ordering spare parts
● Flender order number with item
● Flender drawing number
● Coupling type and size
● Part number (refer to Spare parts drawing and spare parts list (Page 54))
● Dimensions of the pare part, for example:
– Bore
– Bore tolerance
– Parallel keyway and balancing
● Special dimensions, for example, flange connection dimensions, intermediate sleeve length
or brake drum dimensions
N-EUPEX / N-EUPEX DS 3100en
Operating Instructions 10/2017 53
To Next Page
Loading...
