FlexGain FOM16 - Address Setting Menu

FOM16 Installation Description
FOM16-V2.0-20021114
-16-
6.2.4 Address Setting Menu
PATH: CONFIGUREÆADDRESS
1. Use the ◄ key and ► key to cycle through to a proper channel and press the Enter key to
select the address item.
2. Use the ◄ key and ► key to cycle through to a proper channel and press the Enter key to
select the sub-address.
3. Use the ◄ key and ► key to cycle through to a proper sub-address and press the Enter key
to select the address number. You can use the ► key to cycle through to a proper one and
press the Enter key.
4. When completed , the bottom line shows “ -- -- OK -- -- “ message.
5. Press Esc to escape the above state and back to the state below.Press the ► key to select
XXX and repeat the step 2 through 4 to set subaddress XXX.
6. Use the same procedure to set YYY, ZZZ.
7. You may follow the steps below to make sure the address is set correctly:
Local → Status → Address → IP
8.Note: You have to re-power the FOM16 to enable the address setting.
ADDRESS RESET >
Set-Address
IP GWIP TRIP SUB
IP
W W W X X X >
Www.xxx .yyy.zzz
0 1 2 3 4 5 6 7 8 9
0
0 1 2 3 4 5 6 7 8 9
-- -- OK -- --
W W W X X X >
WWW.xxx .yyy.zzz