Flintec FT-112 - Page 59

FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 58 of 170
[
315
PEAK DIS
:
ALL
]
Peak displaying at peak hold.
Page 88
PEAK
LAST
ALL
:
:
:
Display peaks.
Display the final peak.
Display all peaks .
[
316
COLORS
:
RAAY
]
Display color change at SmartAPP operation.
RAAY
YAAR
RBAY
YABR
:
:
:
:
Red, amber, green, amber, yellow
Yellow, amber, green, amber, red
Red, blue, green, amber, yellow
Yellow, amber, green, blue, red
[
317
CHANGE
:
STAB
]
The display color changing at classifying and checkweighing.
IMME
STAB
:
:
Immediately change even scale is not stable.
Change if the scale is stable.
[
318
ACOUSTI
:
OKAY
]
Acoustic warning
NO
OKAY
OVER
CROS
:
:
:
:
Disabled
One beep if okay
One beep if over
One beep at every limit crossing.
[
32-
SMART USAGE
]
SMARTAPP USAGE
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
321
START
:
AUTO
]
Start
MANU
AUTO
SAUT
PORT
:
:
:
:
SmartAPP starts by pressing key or serial port or
digital input.
SmartAPP starts if the load is heavier than empty
range.
SmartAPP starts automatically while the digital input-1
is active.
SmartAPP starts only with serial port command or with
digital input.
[
322
FILLING
:
GROS
]
Filling type.
GROS
NET
:
:
Gross filling.
Net filling after taring the scale automatically.
[
323
TAREDELA
:
0.7
]
Taring delay at filling.
X.X seconds
Automatic taring is done after this delay in net filling.
[
324
TOTAL
:
HORI
]
Totalization type
Page 36
NO
HORI
VERT
:
:
:
Disabled
Horizontal totalization
Vertical totalization
[
325
GT ERASE
:
MRC
]
Grand total erase
Page 92
MRC
PASS
:
:
Erase by pressing MRC key and Enter keys during
GT displaying.
Erase after entering keylock password.
[
326
OUTPUTS
:
STAB
]
Output changing at basic weighing, classifying and
checkweighing. (Appears if the option is installed)
IMME
STAB
:
:
Immediately change even scale is not stable.
Change if the scale is stable.