FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 8 of 170
1200 to 57600 programmable
Length 7 or 8 bits; parity even, odd or none
10 / 100 Mbit/s, Full duplex
Manual IP assign over Indface2x PC Software or by keys in programming mode.
Switched Ethernet transmission with shielded twisted pair cables and RJ-45.
Galvanically isolated bus electronics
Up to 4 ms response delay after read/write commands
Standard USB Micro-B cable
Min. 4 ms response delay after read/write commands
Digital Inputs and Outputs (optional)
Optoisolated 4 digital input, 12 to 28 VDC, 10mA.
Any input(s) can be used as a Remote input of your PLC over BSI or Modbus.
5 free relay contact, 250 VAC or 30 VDC, 0.2A
Any output(s) can be used as a Remote output of your PLC over BSI or Modbus.
Analogue Output (opional)
Programmable dynamic filter
Taring, zeroing, auto zero tracking, motion detection, auto zero at power up, tare
status saves at power off, increased resolution, automatic tare and clear,
temporary gross indication, unit change.
Labelling with barcode, checkweighing, classifying, basic filling, peak holding,
totalization, livestock weighing and free setpoints, functional outputs,
Remote IO of PLC or HMI, fieldbus interface.
ID1, ID2, Limit values for weighing of items / setpoint memory and preset tare
memory.
Each memory size is 500 item records.
PC, PLC, Printer, Remote display, EPL printer etc.
1200 to 57600 programmable
Length 7 or 8 bits; parity even, odd or none
1200 to 57600 programmable
Length 7 or 8 bits; parity even, odd or none