FLIR Ariel CM-3102 - Page 93

Accessing the CM-3102 via a Web Browser
December 12, 2018
Ariel CM-3102 User and Installation Guide
85
 Gain – Set the gain between 0-48 dB. Increasing the gain lightens dark pictures resulting from
low-level lighting. The default is 0.
 Digital WDR – See the explanation in the Auto Mode section above.
In the Day/Night Switch Control section, configure the following setting:
 Mode – See the explanation in the Auto Mode section above.
In the IR Control section, configure the following settings:
 Mode – See the explanation in the Auto Mode section above.
 LED Brightness – See the explanation in the Auto Mode section above.
Click Reset if you want to return to factory default settings.
CM-3102-11-I Exposure Screen
The Exposure screen is used for configuring basic exposure settings and day/night settings. The
configurable settings depend on the selected Exposure mode. In the Exposure section, select one of the
following Exposure modes: Auto Shutter, Flickerless, Auto Iris, or Manual. The choice of the Exposure
mode determines the configurable settings.
Note:
Settings are saved automatically. Clicking Reset returns the settings to factory defaults.
6.3.3.2.1 Auto Shutter Mode
Auto Shutter mode sets the camera’s shutter speed to automatically achieve a consistent video output
level. This mode is recommended for outdoor environments and indoor environments with fluorescent
lighting as the main light source. This is the default setting.
Figure 96: Auto Shutter Exposure Mode Settings