Measurements
7
7.3 Auto-Scan Lock Mode
The auto-scan lock allows for hands-free scanning over a programmable time
period.
Enable the auto-scan lock, and set its timer, in the programming menu (Sec-
tion 9). You can set the timer from 1 minute to 4 hours and 59 minutes.
After enabling the auto-scan lock and setting its timer, hands-free scanning
will begin the next time you pull and release the trigger.
The meter will remain in the Scan mode for the length of time you’ve specified,
after which it will automatically switch to the HOLD mode and power down.
The Lock icon will appear on the upper left corner of the display as shown in
Figure 7.3, below, while scanning.
Figure 7.3 Auto Scan Lock screen showing the LOCK symbol and the flashing SCAN icon.
To end an auto-scan session before the lock timer elapses, pull and release
the trigger.
NOTE
It is possible to set the auto-scan lock timer to 00:00. Doing so allows the meter to continue
testing indefinitely, until the batteries drain.
7.4 MAX, MIN, AVG, and DIF Readings
Each time the trigger is pulled and held (SCAN mode), the Maximum (MAX),
Minimum (MIN), Average (AVG), and Differential (DIF) readings are tracked.
Short press the MODE button to select one of the four modes to monitor while
scanning. The selected reading is shown on the smaller, secondary display
digits, on the lower right of the display. This reading updates in real time as
you scan.
#NAS100131; r. AC/92852/92852; en-US
11
To Next Page
Loading...
