Programming Menu
9
9.12 Programming Menu at a Glance
After reading the in-depth programming menu information above, use Table
9.2, below, as a shortcut to quickly program the meter.
The Setting column lists the desired actions, the Instruction column lists the
steps required, and the Quick Navigation column lists the number of MODE
button presses it requires to move quickly from the first menu screen to the
desired setting.
Table 9.2 Programming menu at a glance.
SETTING INSTRUCTIONS QUICK NAVIGATION
High Alarm Set
Point
Long press MODE (from the HOLD mode) to
access this screen.
Use the arrows to change the set point.
Press LOG to choose a preset.
Press MODE to step to the next parameter.
First screen in menu.
Low Alarm Set
Point
Use the arrows to change the set point.
Press MODE to step to the next parameter.
Press MODE once
from first screen.
Emissivity Use the arrows to set the emissivity.
Press LOG to choose a preset.
Press MODE to step to the next parameter.
Press MODE 2 times
from first screen.
Temperature
Units
Use the arrow buttons to change the units.
Press MODE to step to the next parameter.
Press MODE 3 times
from first screen.
Auto-Scan
Lock
Use the arrows to set the Auto-Scan Lock ON
or OFF.
Use the LOG button to select the timer’s Mi-
nutes and Hours fields and use the arrows to
change the time.
Press MODE to step to the next parameter.
Press MODE 4 times
from first screen.
Laser Pointer Use the arrows to enable or disable the laser.
Press MODE to step to the next parameter.
Press MODE 5 times
from first screen.
#NAS100131; r. AC/92852/92852; en-US
24
To Next Page
Loading...
