Data Logger10
• Readings are taken at the interval (rate) that you have specified.
• Data logging stops when the number of readings that you have selected
has been reached.
10.3 Recalling and Deleting Logged Readings
To recall logged readings, short press either arrow button from the HOLD
mode. The first memory bank you will see is the manual data log memory, as
shown at left in Table 10.2, below. Use the arrow buttons to step through
logged readings, long press to scroll quickly.
To switch to the automatic data logger memory bank (from the manual memo-
ry), short press the LOG button. The automatic data log memory screen is
shown, below on right, in Table 10.2.
Table 10.2 Recalling logged readings.
Manual data log recall screen
Auto logging (Auto Interval) recall
screen
1. Logged reading.
2. Time and date stamp of reading.
3. Memory location (in automatic memory mode, the text Auto Interval is al-
so shown).
4. Emissivity setting at the time the reading was logged.
5. The OK icon indicates that there were no alarms active when the reading
was logged. If there was a high or low alarm condition the display would
show the HI or LO icon.
To delete a reading, long press the LOG button until the display flashes. When
a reading is deleted, the reading digits switch to four dashes.
#NAS100131; r. AC/92852/92852; en-US
28
To Next Page
Loading...
