Quick Start
4
1. Point the camera at a surface to test.
2. Pull and hold the trigger to scan surfaces. SCAN will flash on the display
and the reading, shown at center, will track temperature changes in real
time.
Figure 4.1 SCAN mode display.
3. The reading on the display, when you release the trigger, will be held for 5
or 15 seconds (as set in the programming menu, see Section 9) and the
meter will then switch off. HOLD will show on the display while the reading
is held.
Figure 4.2 HOLD mode display.
4. If the measurement does not exceed an alarm limit, the display will show
OK, otherwise HI or LO will flash on the display, indicating that a high or
low alarm has been triggered (Section 8).
5. Actions that can be performed in the SCAN and HOLD modes are listed in
Table 4.1, below.
#NAS100131; r. AC/92852/92852; en-US
4
To Next Page
Loading...
