Programming Menu
9
9.10 Setting Auto Power OFF (APO)
If you are continuing from the previous menu, use the arrow buttons to set the
APO to 5 or 15 seconds. This is the amount of time that the meter will HOLD
a reading after the trigger is released, before switching off.
To access this setting with the meter off, pull and release the trigger to enter
the HOLD mode, long press the MODE button to enter the program menu,
and then press the MODE button eight times. Now use the arrows to set 5 or
15 seconds.
Figure 9.7 Setting the Auto Power OFF (APO) time.
To save the setting and return to the normal operation mode, pull and release
the trigger. Otherwise press the MODE button to move to the calibration date
parameter.
9.11 Viewing the Calibration (CAL) Date
If you are continuing from the previous menu, simply view the date of the most
recent calibration and then press MODE to return to the normal operation
mode.
To access this setting with the meter off, pull and release the trigger to enter
the HOLD mode, long press the MODE button to enter the program menu,
and then press the MODE button nine times. View the date of the most recent
calibration and then press MODE to exit the programming menu.
Figure 9.8 View the date of the latest calibration.
#NAS100131; r. AC/92852/92852; en-US
23
To Next Page
Loading...
