Programming Menu
9
Figure 9.3 Setting the temperature units.
To save the setting and return to the normal operation mode, press and re-
lease the trigger. Otherwise press the MODE button to move to the Lock
parameter.
9.6 Setting the Auto-Scan Lock mode
When the auto-scan lock mode (hands-free scanning) is active, you can pull
and release the trigger and scan for a programmable time period without hav-
ing to hold the trigger.
If you are continuing from the previous menu, use the arrow buttons to set the
lock ON or OFF and then set the timer from 1 minute to 4 hours and 59 mi-
nutes. Use the LOG button to switch between the hours and minutes fields,
and use the arrow buttons to set the timer. When the digits are flashing, they
are ready to be changed.
When no digits are flashing, pull and release the trigger to start hands-free
scanning. If you prefer to start the scanning at a later time, short press the
MODE button to continue through the programming menu. At a later time you
can pull and release the trigger to start hands-free scanning.
Figure 9.4 Setting Auto-Scan ON and setting the timer.
#NAS100131; r. AC/92852/92852; en-US
19
To Next Page
Loading...
