Programming Menu
9
Figure 9.6 Select the 12/24 clock mode first, and then set the calendar clock (from left to
right: year, month, date, hours, minutes, AM/PM).
To save the setting and return to the normal operation mode, press and re-
lease the trigger. Otherwise press the MODE button to move to the Auto Inter-
val (data logger) parameter.
9.9 Setting the Auto Interval (Data Logger)
Important note: Before you begin configuring the data logger, set the meter’s
time and date as explained in Section 9.8, otherwise the data logger will not
operate as expected.
If you’re continuing from the previous menu, follow the steps in Table 9.1,
below.
To access this setting with the meter off, pull and release the trigger to enter
the HOLD mode, long press the MODE button to enter the program menu,
and then press the MODE button seven times. Follow the steps in Table 9.1 ,
below:
Table 9.1 Setting up the Auto Interval (automatic data logger) function.
Use the arrow buttons to set the mode ON (or OFF).
Press the LOG button to move to the next screen.
#NAS100131; r. AC/92852/92852; en-US
21
To Next Page
Loading...
