Programming Menu
9
Table 9.1 Setting up the Auto Interval (automatic data logger) function. (continued)
Use the arrow buttons to set the exact date and time that
automatic data logging will begin. Use the LOG button to
step from field to field and then to the next step. Digits flash
when they are ready to be edited.
Use the arrow buttons to set the sampling rate (interval of
time between readings) from 1 minute to 96 hours and 59
minutes (00:01 to 96:59). Use the LOG button to step from
hours to minutes and then to the next step.
Use the arrow buttons to select the number of readings to
log (99 maximum).
Press LOG to complete the setup.
Press the MODE button to move to the next parameter (APO) or pull and re-
lease the trigger to exit the programming mode.
After configuring the Auto Interval (automatic data logger) function, as de-
scribed above, the meter will perform the following actions automatically:
• The meter will start logging at the time and date that you have designated.
• Readings will be taken at the interval (rate) that you have specified.
• Data logging will stop when the number of readings that you have selected
has been reached.
See Section 10 for details on recalling/deleting readings, and switching be-
tween manual and automatic memory banks.
#NAS100131; r. AC/92852/92852; en-US
22
To Next Page
Loading...
