Data Logger10
Table 10.1 Setting up the Auto Interval (automatic data logger) function.
Use the arrow buttons to set the mode ON (or OFF).
Press the LOG button to move to the next screen.
Use the arrow buttons to set the exact date and time that
automatic data logging will begin. Use the LOG button to
step from field to field and then to the next step. Digits flash
when they are ready to be edited.
Use the arrow buttons to set the sampling rate (interval of
time between readings) from 1 minute to 96 hours and 59
minutes (00:01 to 96:59). Use the LOG button to step from
hours to minutes and then to the next step.
Use the arrow buttons to select the number of readings to
log (99 maximum).
Press LOG to complete the setup.
After configuring the automatic data logger, the meter performs the following
actions automatically:
• The meter starts logging at the time and date that you have designated.
#NAS100131; r. AC/92852/92852; en-US
27
To Next Page
Loading...
