FLIR ThermaCAM P65

Value (examples)Label (examples)
Room 1Section
Tool 1Equipment
RepairRecommendation
10.2.2.7.1 Beaming a text comment file to the camera
Follow this procedure to beam a text comment file to the camera:
ActionStep
ThermaCAM Reporter 7.0 – a reporting software from FLIR Systems – provides a
user-friendly interface to create text comment files.
For more information about using the text comment editor in ThermaCAM Reporter
7.0, consult any of the following manuals:
■
ThermaCAM™ Reporter Pro 7.0 Manuel d’utilisation (1 557 790)
■
ThermaCAM™ Reporter Pro 7.0 Bedienungsanleitung (1 557 792)
■
ThermaCAM™ Reporter Pro 7.0 Manual del usuario (1 557 794)
■
ThermaCAM™ Reporter Pro 7.0 Manuale dell'operatore (1 557 796)
■
ThermaCAM™ Reporter Pro 7.0 User's Manual (1 557 788)
You can also create the text comment in any ASCII text editor. For more information
about creating a text comment file in an ASCII text editor, see section 8.5 – Creating
a text comment file on page 55
1
Transfer the *.tcf file to your PDA (or laptop, if you created the file on a desktop
computer).
2
Point to Power on the Setup menu to display the Power Setup dialog box.3
Move the joystick left/right to enable or disable IrDA.4
Press the joystick to confirm the change and leave the dialog box.5
Point to Text comment on the File menu in ThermaCAM™ P65 and press the joy-
stick.
6
Beam the file from the PDA (or laptop) to ThermaCAM™ P65. A dialog box will
confirm receipt of the file.
7
10
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006 93
10 – Camera program