FLIR ThermaCAM P65

10.2.5.5 Digital video
➲ Depending on your camera configuration, one of the digital video modes (DV or
DCAM) may be an extra option.
10402903;a2
Figure 10.56 Digital video dialog box
Figure 10.57 Explanations of the Digital video dialog box
CommentsValueLabel
➲ Disconnect the FireWire cable from the camera
before carrying out this procedure.
Move the joystick left/right to select digital video
mode (DV or DCAM).
■
DCAM
■
DV
Mode
➲ Link status settings should only be changed
when DV mode is selected above.
■
When establishing a connection between the
camera and a passive digital video unit – such
as a DV recorder – the image transmission
needs to be activated from the camera. To do
this, move the joystick left/right to select Active.
■
When establishing a connection between the
camera and an active digital video unit – such
as a PC – the unit itself will activate and deacti-
vate the image transmission.
■
Active
■
Idle
Link
10.2.5.6 Bluetooth®
10567603;a2
Figure 10.58 Bluetooth® dialog box
➲ Depending on your camera configuration, this feature may be an extra option.
Follow this procedure to connect a Bluetooth® headset to the camera:
ActionStep
On your headset, set up the Bluetooth® bond. For information about how to do
this, consult the documentation for the headset.
1
In the dialog box above, click Scan. The camera will now scan for devices enabled
for Bluetooth® and list these in the dialog box.
2
Select the headset by moving the joystick up/down.3
10
120 Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006
10 – Camera program