ActionStep
Enter the pin code for the headset. You will find the pin code by consulting the
documentation for the headset, but it is most likely 0000. After having entered the
pin code, the dialog box will be closed.
4
Now click Voice Comment on the File menu. The camera will to connect with the
headset and you can start adding voice comments.
5
➲ This procedure only needs to be done the first time you use a new headset featuring
Bluetooth® wireless technology.
For information about voice comments, see section 10.2.2.6 – Voice comment on
page 91.
10.2.5.7 Power
10588103;a2
Figure 10.59 Power Setup dialog box
Figure 10.60 Explanations of the Power Setup dialog box
CommentsValueLabel
Move the joystick left/right to specify the time after
which the camera will be switched off if it is not
used.
■
None
■
10 min
Auto power off
Move the joystick left/right to specify the time after
which the display will be switched off if it is not
used.
■
None
■
30 sec
■
60 sec
Display power off
Move the joystick left/right to specify the level of
background illumination of the LCD.
■
Low
■
Medium
■
High
LCD illumination
Move the joystick left/right to enable or disable the
IrDA infrared communication link.
■
On
■
Off
IrDA
➲ For protective reasons, the LCD will be switched off if the detector temperature
exceeds +60 °C (+149 °F) and the camera will be switched off if the detector temper-
ature exceeds +68 °C (+154.4 °F)
10
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006 121
10 – Camera program
To Next Page
Loading...
