FLIR ThermaCAM P65

10.2.2.3 Copy to card
Point to Copy to card to copy the contents of the internal image folder to a automati-
cally created folder on a CompactFlash® card
10.2.2.4 Periodic save
10389603;a3
Figure 10.8 Periodic save dialog box
Point to Periodic save and press the joystick to display the Periodic save dialog box.
Using the periodic save feature, you can save a number of images, at a certain se-
lectable periodicity, to the internal flash memory or the CompactFlash card. Together
with the images, all the current conditions will be saved.
Figure 10.9 Explanations of the Periodic save dialog box
CommentActionTask
The periodicity can be set from
10 seconds up to 24 hours. Se-
lect Fast → On for shortest pos-
sible time interval (< 10 sec-
onds).
Move the joystick left/rightSetting the periodicity
Press the joystickStarting the recording
Press the joystick again
➲ Images will be stored sequentially in the current directory. If the
recording is stopped and then started again the new images will be
added at the end of the previous sequence in the same directory.
Stopping the recording
10.2.2.5 Burst recording
➲ Depending on your camera configuration, this feature may be an extra option. The
RAM memory allocated for burst recording is 128 MB. This memory is only used to
temporarily save SEQ or AVI files during burst recording. As soon as you exit the
burst recording dialog you will need to save the files either in the internal flash mem-
ory, or on an external CompactFlash card.
Point to Burst recording and press the joystick to display the Burst recording dialog
box. Using the burst recording feature, you can:
■ record and save a sequence of frames at a very high speed
10
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006 89
10 – Camera program