ExplanationCommand
Point to Avg and press the joystick to display the average tempera-
ture along the line.
Avg
See below.Settings
Point to Settings and press the joystick to display a Line settings dialog box where
you can change the settings for the line.
10588803;a2
Figure 10.32 Line dialog box
Figure 10.33 Explanations of the Line dialog box
CommentsValueLabel
Select On to set the emissivity, the reflected tem-
perature, and the distance for this line only.
Selecting On will also assign an asterisk to the
measurement marker’s label.
■
On
■
Off
Local
You can set the Emissivity if Local is enabled. If
not, this option will be shaded.
➲ If you enter an emissivity value less than 0.30
the emissivity box will begin flashing to remind you
that this value is unusually low.
User-defined
(0.01–1.00)
Emissivity
10
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006 105
10 – Camera program
To Next Page
Loading...
