Operating the Machine
40
04/03/2020 218333
Item
Image Type Function
9
Three-arm-
lever
The operator moves the spindle up and down using the drill
lever during the machining operation.
10
Fixed limiter Is used during the drilling operation to mechanically limit a
drilling depth.
The limiter is active when it is pushed completely onto the
three-arm-lever axle.
The limiter is deactivated when it is pulled out in the direc-
tion of the three-arm-lever.
11
Main switch Only for SB/TB/TBZ 20/23’/25 Plus
Switches the power supply of the machine on or off.
Emergency stop button (push-button)
The control panel emergency stop button is used by the operator as a safety
switch while working on and with the machine.
You can use the emergency stop button to immediately stop all drives and
movements of the machine in the event of imminent danger, regardless of the
currently selected operating mode or function.
In the event of an interruption by emergency stop, the machine and the
movements triggered by the actuation push-buttons are stopped immediately,
i.e. they do not continue to move. The drive motor and drill light are switched
off.
To stop the machine immediately, simply press the emergency stop button.
Note
However, you should normally not use the emergency stop button to shut
down the machine (normal shutdown), since this immediately stops the con-
trolled movement of the machine.
Always press the emergency stop button only in case of danger or to reset the
control system.
The emergency stop button is self-locking. This means that you cannot oper-
ate the machine until you have eliminated the cause for the interruption and
unlocked the actuated emergency stop button.
To Next Page
Loading...
