Installing the Dynamic Seal Maintenance kit
Use this procedure when installing the Dynamic Seal Maintenance kit on your HyPlex Prime pump.
Tools
•
Pressure loading tool assembly, 049512-1
•
Combination wrenches (14-32 mm)
•
½ in. drive socket set (14-32 mm)
•
½ in. torque wrench (0-100 ft-lb)
•
Screwdriver set
Maintenance kit
•
Dynamic Seal Maintenance kit, 050626-1
Service notes
•
All parts of the kit should be installed at the same
time - do not replace components individually.
•
All components should be clean and free of debris
prior to assembly. Keeping the work area clean is im
-
portant while working on the equipment.
•
Read the entire procedure before beginning service,
paying particular attention to safety instructions.
CAUTION
Failure to follow these step-by-step instructions and
the procedures in your service manual could result in
premature failure or damage to the equipment.
© Flow International Corporation M-416 | 45
CHAPTER 4
Service
To Next Page
Loading...
