Installing the Minor Maintenance kit
This service is performed at specified intervals for the life of the equipment. The complete service schedule for the mi
-
nor maintenance kit (and the major maintenance kit) is described on Page 26.
Tools
•
Pressure loading tool, 049512-1
•
Combination wrenches (14-32 mm)
•
½ in. drive socket set (14-32 mm)
•
½ in. torque wrench (0-100 ft-lb)
•
Screwdriver set
•
Snap-ring pliers
•
Rebuild clamp or 6 in. soft jaw vise
Maintenance kit
•
Minor Maintenance Kit, 050624-1
Service notes
•
All parts of the kit should be installed at the same
time - do not replace components individually.
•
All components should be clean and free of debris
prior to assembly. Keeping the work area clean is im
-
portant while working on the equipment.
•
Read the entire procedure before beginning service,
paying particular attention to safety instructions.
CAUTION
Failure to follow these step-by step instructions
could cause premature parts failure and/or
damage to the equipment.
© Flow International Corporation M-397 | 55
CHAPTER 5
Service
To Next Page
